AL300ULM multi-output access control power supply/charger is specifically designed for use with access control systems and accessories. This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs. Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

Input

• Input 115VAC / 60Hz, 3.5A.
• Input fuse rated @ 3.5A/250V.
• Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C.supervised trigger input and polarity reversal trigger input.

• CA-6 transformer used with CF-2C control unit (700 mA max. current)
• Made of durable, molded plastic
• Provides 12 VAC output
• Included with respective control units

Features

• 1, 4 or 8 polyswitch (PTC) 2A circuit breakers based on model
• LEDs monitor zone status (voltage, no voltage)
• Slide switches connect or disconnect load from power (excludes 1 Amp)
• Sealed lead acid-gel battery charging capability (battery not included)
• Rugged steel enclosure
• Provided with terminals for fire alarm relay connection, allowing release of all devices upon fire alarm activation
• Clean linear power for flawless operation with all sensitive active electronic components
• BPS UL Listed
• MagnaCare lifetime replacement, no fault warranty