S2K Commerce - Products Dropdown
ActionsS2K Commerce - Shopping Cart
ActionsS2K Commerce - Order Entry
ActionsFlame and Impact resistant black polymer (ABS) 1 3/4 W X 4 1/2 H X 1 1/2 D inches
The Model EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linears receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the antenna to a wall or vertical wood brace or beam.
NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio range will be.
The EXA-1000 is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with an F connector attachment; a Base Plate assembly with radial mounting provisions; and a five-foot, 75-ohm coaxial cable. The cable connects to the antenna base on one end and the receivers F connector on the other. If the antenna must be mounted further than five feet from the receiver, an extension cable of up to a maximum of 25 feet may be used instead of the five foot cable supplied. Because of the cable resistance, the performance of the EXA-1000 may be degraded by using longer than a 25 foot cable.
Features
- Compatible with all Linear receivers with Type F antenna connector
- Receives signals in 288 to 320 MHz range
- Omni-directional remote antenna
- Includes 5 feet of coax
- U-bolt for post mounting
- Dimensions: 3 W x 19.5 H x 6 D in.
- Order number: AAE00198
- Portable, easy to set up
- Edge-based installation at the door
- Demonstrates the features and capabilities of an infinias IPbased access control solution
- Demo kit includes an infinias PoE-enabled eIDC32 door controller and HID Prox Point Plus mini mullion card reader mounted to a surface mount box
- LEDs and buttons are wired to the eIDC32 door controller to simulate a working door
- Intelli-M Access Software enables managing, viewing and reporting activity
- Demo kit also includes: Prox card samples from infinias and a short arm security hex key