|◀ ◀ 589 - 600 of 747 ▶ ▶|
View:

Access and Power Integration - Kit includes Trove1R enclosure with Altronix / HID VertX® TV1R backplane

Altronix T1RV3F4 rack kit is pre-assembled and consists of Trove1M1R enclosure/backplane with factory installed Altronix power supply/charger and sub-assemblies. This kit also accommodates various combinations of HID VertX® boards for up to six (6) doors in a single enclosure.
Power Supply (eFlow6NB):
Input
  • Voltage: 120VAC, 60Hz, 3.5A max.
  • Fusing: 5A / 250V.
Output
  • Voltage: Factory set at 24VDC.
  • Current: 6A continuous.
  • Maximum Supply Current for Main and Aux. Outputs on eFlow6NB Power Supply board, PDS8 Power Distribution Module’s and ACM4 Access Power Controller’s outputs is 5.6A.
  • Auxiliary: Class 2 power-limited @ 1A (unswitched).
  • Other: Overvoltage protection. Filtered and regulated.
Battery Backup
  • Built-in charger for sealed lead acid or gel type batteries (if batteries are required, install separate battery enclosure RE2).
  • Automatic switch over to stand-by battery when AC fails.
  • Zero voltage drop when unit switches over to battery backup (AC failure condition).
Fire Alarm Disconnect
  • Supervised: Latching or non latching.
  • EOL: 10K Resistor.
Supervision
  • AC Failure: Form “C” contacts.
  • Battery: Form “C” contacts.
  • Low DC Power Shutdown: Shuts down DC output terminals if battery voltage drops below 70-75% for 24V units. Prevents deep battery discharge.
Indicators LED
  • Input: 120VAC is present.
  • DC Output: Powered.
  • Battery: Discharged or not connected.
Access Power Controller (ACM4):
Input
  • Voltage: 24VDC from eFlow6NB.
  • Fusing: 10A / 250V.
Output
  • Voltage: 24VDC.
  • Four (4) independently controlled 2.5A outputs:
  • a) Four (4) Fail-Safe and/or Fail-Secure power outputs.
  • b) Four (4) dry form “C” 5A rated relay outputs.
  • c) Any combination of the above.
  • Four (4) auxiliary power outputs (unswitched).
  • Fuses Rating: 3A / 32VDC.
Indicators (LED)
  • Red LEDs: Outputs are triggered (relays energized).
  • Blue LED: FACP disconnect is triggered.
Power Distribution Module (PDS8):
Input
  • Voltage: 24VDC from eFlow6NB and 12VDC from VR6.
  • Fusing: 10A / 250V.
Output
  • Voltage: 12 or 24VDC individually selectable.
  • Fuses Rating: 3A / 32VDC.
Indicators (LED)
  • DC Output: Eight (8) individual output LEDs.
Item#:
T1RV3F4
You must be logged in to order this item. Log in here

16-Door Altronix/Software House Access and Power Integration Kit

Altronix T3SK75F16D is pre-assembled and consists of Trove3 enclosure with factory installed Altronix power supply/chargers and sub-assemblies. These kits also accommodates various combinations of Software House boards for up to sixteen (16) doors in a single enclosure.

  • Input: 120VAC 60Hz/8.0A.
  • Output:
    • 24VDC up to 9.2A max current.
    • sixteen (16) Fail-Safe/Fail-Secure Auto-Resettable Outputs
  • Fully assembled kit includes:
    • Trove3 enclosure with TSH2 backplane
    • One (1) eFlow104NB - Power Supply/Charger
    • One (1) eFlow102NB - Power Supply/Charger
    • Two (2) ACM8CB - PTC Protected Access Power Controllers
    • One (1) PD8ULCB - PTC Protected Power Distribution Module
    • One (1) Rocker Switch Bracket with Two (2) Rocker Switch
  • Back-up Battery (not included):
    • Capacity: 12AH / 12VDC (Up to 4 within enclosure); 40 AH / 65 AH (requires separate enclosure).
    • Type - Sealed lead acid or gel type.
    • Fuse Rating: 15A/32V.
    • Failover - Upon AC loss, instantaneous.
  • Supervision:
    • AC Failure - Form "C" contacts.
    • Battery - Form "C" contacts.
    • Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
  • LED Indicators:
    • Input - 120VAC is present.
    • DC Output - Powered.
    • Battery - Discharged or not connected.

Item#:
T3SK75F16D
You must be logged in to order this item. Log in here

Trove2 Backplane for Altronix/DMP

  • 16 AWG backplane.
  • Includes mounting hardware.
  • Accommodates the following DMP 734 and 734N Wiegand modules with or without Altronix power/accessories: DMP 734 and 734N Wiegand modules, Altronix Power Supplies, Altronix Sub-Assemblies
  • Simplifies board layout and wire management
  • 16 AWG galvanized steel

Item#:
TDM2
You must be logged in to order this item. Log in here

365 Day Timer

Item#:
TD365
 
Spec Sheet
You must be logged in to order this item. Log in here

Trove2 Blank/Customizable Backplane

TBL2 backplane allows you the option of drilling your own mounting holes to accommodate the access controller boards, power supplies and accessories to customize your own access system. Trove simplifies board layout and wire management, reducing installation time and labor costs.

  • 16 AWG backplane.
  • Includes mounting hardware.
  • Simplifies board layout and wire management
  • 16 AWG galvanized steel

Item#:
TBL2
You must be logged in to order this item. Log in here

KT-300 transformer, wire-in, 2 20 VAC / 16 VAC (37 VA), CE ap

Item#:
TR1640W-220
You must be logged in to order this item. Log in here

2 PIN Mortise Transfer 1.5A @ 24VAC, white finish

Item#:
9500
 
Spec Sheet
You must be logged in to order this item. Log in here

Altronix/HID-Vertx House Access & Power Integration Enclosure w/Backplane

Trove3 enclosure with TV3 Altronix/HID VertX backplane:

  • Backplane accommodates a combination of HID VertX controllers with or without Altronix accessories: HID Vertx V100, V200, V300, V1000, V2000, and Genetec Synergis Cloud Link, Altronix Power Supplies, Altronix Sub-Assemblies
  • Includes Altronix Trove3 Enclosure and one (1) removable TV3 backplane
Trove3 Enclosure:
  • 16 AWG powder coated steel enclosure with a single 2" center knockout on the top of the enclosure plus (16) 2-Stage knockouts for 0.75" or 1" conduit.
  • Includes: One (1) cam lock, one (2) tamper switch and mounting hardware.

Item#:
TROVE3V3
You must be logged in to order this item. Log in here

16-Door Altronix/Software House Access and Power Integration Kit

Altronix T3SK75F16 is pre-assembled and consists of Trove3 enclosure with factory installed Altronix power supply/chargers and sub-assemblies. These kits also accommodates various combinations of Software House boards for up to sixteen (16) doors in a single enclosure.

  • Input: 120VAC 60Hz/8.0A.
  • Output:
    • 24VDC up to 9.2A max current.
    • Sixteen (16) Fail-Safe/Fail-Secure or Dry Form "C" Outputs
  • Fully assembled kit includes:
    • Trove3 enclosure with TSH3 backplane
    • One (1) eFlow104NB - Power Supply/Charger
    • One (1) eFlow102NB - Power Supply/Charger
    • Two (2) ACM8 - Fused Access Power Controller
    • One (1) PD8UL - Fused Power Distribution Module
    • One (1) Rocker Switch Bracket with Two (2) Rocker Switch
  • Back-up Battery (not included):
    • Capacity: 12AH / 12VDC (Up to 4 within enclosure); 40 AH / 65 AH (requires separate enclosure).
    • Type - Sealed lead acid or gel type.
    • Fuse Rating: 15A/32V.
    • Failover - Upon AC loss, instantaneous.
  • Supervision:
    • AC Failure - Form "C" contacts.
    • Battery - Form "C" contacts.
    • Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
  • LED Indicators:
    • Input - 120VAC is present.
    • DC Output - Powered.
    • Battery - Discharged or not connected.

Item#:
T3SK75F16
You must be logged in to order this item. Log in here

TROVE3 ALTRONIX/JCI BACKPLANE

Item#:
TJC3
You must be logged in to order this item. Log in here

Altronix/Mercury-Lenel Access and Power Integration Enclosure w/Backplane

Trove3 enclosure with TM3 Altronix/Mercury backplane:

  • Backplane accommodates a combination of Altronix and Mercury boards: Mercury: EP1502, EP4502, MR52, MR16IN, MR16OUT, EP2500, MUX8, and Genetec Synergis Cloud Link, Altronix Power Supplies, Altronix Sub-Assemblies
  • Includes Altronix Trove3 Enclosure and one (1) removable TM3 backplane
  • Door accommodates TMV2 backplane (sold separately).
Trove3 Enclosure:
  • 16 AWG powder coated steel enclosure with a single 2" center knockout on the top of the enclosure plus (16) 2-Stage knockouts for 0.75" or 1" conduit.
  • Includes: One (1) cam lock, one (2) tamper switch and mounting hardware.

Item#:
TROVE3M3
You must be logged in to order this item. Log in here

8-Door Altronix/Keyscan Access and Power Integration Kit

AAltronix T2KK3F8D is pre-assembled and consists of Trove2 enclosure with factory installed Altronix power supply/chargers, transformer, and sub-assemblies. These kits also accommodates various combinations of Keyscan boards for up to eight (8) doors in a single enclosure.

  • Input: 120VAC 60Hz/3.5A.
  • Output:
    • 24VDC up to 5.8A max current.
    • Eight (8) Fail-Safe/Fail-Secure Outputs (auto-resettable)
  • Fully assembled kit includes:
    • Trove2 enclosure with TKA2 backplane
    • One (1) eFlow6NB - Power Supply/Charger
    • One (1) ACM8CB - PTC Access Power Controller
    • One (1) T16100 Transformer
  • Back-up Battery (not included):
    • Capacity: 12AH / 12VDC (Up to 4 within enclosure); 40 AH / 65 AH (requires separate enclosure).
    • Type - Sealed lead acid or gel type.
    • Fuse Rating: 10A/32V.
    • Failover - Upon AC loss, instantaneous.
  • Supervision:
    • AC Failure - Form "C" contacts.
    • Battery - Form "C" contacts.
    • Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
  • LED Indicators:
    • Input - 120VAC is present.
    • DC Output - Powered.
    • Battery - Discharged or not connected.

Item#:
T2KK3F8D
You must be logged in to order this item. Log in here
|◀ ◀ 589 - 600 of 747 ▶ ▶|
View:
(Denotes required field.)