|◀ ◀ 565 - 576 of 747 ▶ ▶|
View:

Power supply for RA-4961-K1Q. 6VDC, 500mA, 2.1mm plug, cente

Item#:
X-HKP06-06005
You must be logged in to order this item. Log in here

Trove3 Backplane for Altronix/Software House

  • 16 AWG backplane.
  • Includes mounting hardware.
  • Accommodates the following Software House iStar Ultra series access controllers with or without Altronix power/accessories: iStar Ultra GCM and iStar Ultra ACM boards or iSTAR Pro GCM and iSTAR ACM SE/PRO ACM boards, as well as I8, R8, and I8-CSI boards, Altronix Power Supplies, Altronix Sub-Assemblies
  • Simplifies board layout and wire management
  • 16 AWG galvanized steel

Item#:
TSH3
You must be logged in to order this item. Log in here

4612 SHORT ELECTROLYNX SWING C LEAR

Item#:
4612EL-1SC
You must be logged in to order this item. Log in here

3A Power Supply Charger with Enclosure

SECO-LARM’s ST-2406-3AEQ power supply/charger ensures that alarm systems and access control systems have enough power to do their job. Protected by fused battery outputs, input polarity protection diodes, and backup battery polarity reverse protection, this power supply/charger can be used to maximize the security and efficiency of nearly any alarm or access control installation. Enclosure has space for up to 2 backup batteries (leads included for one optional backup battery).
  • Automatic recharging of backup batteries
  • Automatic switchover to backup battery if main power is lost or cut
  • Built-in battery short-circuit protection
  • Low-battery cutoff
  • LEDs indicate power status
  • Programmable DC voltage output
  • Regulated and filtered output voltage
  • Fused output for a regulated charge
  • Heavy-duty steel case to protect power connections
  • Enclosure has space for up to two 4Ah or one 7Ah backup batteries
  • Includes battery leads for easy installation
  • High efficiency at full load
  • Heat sink free design
Item#:
ST-2406-3AEQ
You must be logged in to order this item. Log in here

3.0A Voltage Converter.

ENFORCER Power Converters “step down” voltage, converting low-voltage AC or DC into regulated DC outputs. These converters are useful for DC CCTV cameras, access controls, and many other applications where low-voltage DC output is required.
  • Three models available, providing varying degrees of low-voltage DC output
  • Built-in overload protection
  • Regulated and filtered output
  • Green LED indicates power input
  • Red and Blue LEDs indicate power output
Item#:
ST-LA130-TTQ
You must be logged in to order this item. Log in here

Altronix/Honeywell-NetAXS Access & Power Integration Enclosure w/Backplane

Trove2 enclosure with THN2 Altronix/Honeywell NetAXS backplane:

  • Backplane accommodates a combination of Honeywell NetAXS access controllers with or without Altronix power /accessories: Honeywell NetAXS -NX4PCB, NetAXS-123, NXD1 or NXD2, NX4IN or NX4OUT, Altronix Power Supplies, Altronix Sub-Assemblies
  • Includes Altronix Trove2 Enclosure and one (1) removable THN2 backplane
Trove2 Enclosure
  • 16 AWG powder coated steel enclosure with a single 2" center knockout on the top of the enclosure plus (16) 2-Stage knockouts for 0.75" or 1" conduit.
  • Includes: One (1) cam lock, one (1) tamper switch and mounting hardware.

Item#:
TROVE2HN2
You must be logged in to order this item. Log in here

(4) Door, PTC Outputs Kit

Altronix Trove Mercury kits are pre-assembled and consists of Trove1M1 enclosure/ backplane with factory installed Altronix power supply/charger and sub-assemblies. These kits also accommodates various combinations of Mercury boards for up to four (4) doors in a single enclosure. Trove simplifies board layout and wire management, reduces installation time and labor costs.

  • Power Supply (eFlow4NB):
    • Input:
      • Voltage: 120VAC, 60Hz.
      • Fusing: 5A / 250V.
    • Output:
      • Voltage: 24VDC.
      • Current: 4A continuous.
      • Other: Overvoltage protection. Filtered and regulated.
  • Battery Backup:
    • Capacity: 7AH / 12VDC (Up to 2 within enclosure). 40 AH / 65 AH (requires separate enclosure).
    • Type: Sealed lead acid or gel type.
    • Fuse: Rating 10A/32V.
    • Failover: Upon AC loss, instantaneous.
  • Supervision:
    • AC Failure: Form "C" contacts.
    • Battery: Form "C" contacts.
    • Low DC Power Shutdown: Shuts down DC output terminals if battery voltage drops below 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
  • Indicators LED:
    • Input: 120VAC is present.
    • DC Output: Powered.
    • Battery: Discharged or not connected.
  • Voltage Regulator (VR6):
    • Input: Voltage: 24VDC from eFlow4NB.
  • Output:
    • Voltage: 12VDC.
    • Current: 6A continuous.
    • Other: Surge suppression.
  • Indicators (LED):
    • Input: 24VDC is present.
    • Output: Powered.
  • Access Power Controller (ACM4CB):
    • Input:
      • Voltage: 24VDC from eFlow4NB.
      • Fusing: 10A / 250V.
    • Output:
      • Voltage: 24VDC.
      • Four (4) independently controlled 2.5A outputs:
      • a) Four (4) Fail-Safe and/or Fail-Secure power outputs.
      • b) Any combination of the above.
      • Four (4) auxiliary power outputs (unswitched).
    • Outputs Ratings: PTCs: 2.5A.
    • Indicators (LED):
      • Red LEDs: Outputs are triggered (relays energized).
      • Green LED: FACP disconnect is triggered.

Item#:
T1MK1F4D
You must be logged in to order this item. Log in here

Altronix/Salto Access and Power Integration Enclosure with Backplane

Trove1 enclosure with TSA1 Altronix/SALTO backplane:

  • Backplane accommodates a combination of SALTO Modules with or without Altronix accessories: SALTO: CU42E0, Altronix Power Supplies, Altronix Sub-Assemblies
  • Includes Altronix Trove1 Enclosure and one (1) removable TSA1 backplane
Trove1 Enclosure:
  • 16 AWG black enclosure with a single 1.5" center knockout on the top of the enclosure plus (9) 2-Stage knockouts for 0.75" or 1" conduit.
  • Includes: One (1) cam lock, one (1) tamper switch and mounting hardware.

Item#:
TROVE1SA1
You must be logged in to order this item. Log in here

8-Door Altronix/Mercury-Lenel Access and Power Integration Kit

Altronix T2MK3F8DQ is pre-assembled and consists of Trove2M2 enclosure with factory installed Altronix power supply/charger(s) and sub-assemblies. This kit also accommodates various combinations of Mercury boards for up to eight (8) doors in a single enclosure.

  • Input: 120VAC 60Hz/3.5A.
  • Output:
    • 24VDC up to 5.8A max current.
    • Eight (8) Fail-Safe/Fail-Secure or Dry Form "C" Outputs
  • Fully assembled kit includes:
    • Trove2 enclosure with TM2 backplane
    • One (1) eFlow6NB - Power Supply/Charger
    • One (1) LINQ2 - Network Communications Module
    • One (1) ACM8CB - PTC Access Power Controller
    • One (1) VR6 - Voltage Regulator
    • One (1) PDS8CB - Dual Input Power Distribution Module

Item#:
T2MK3F8DQ
You must be logged in to order this item. Log in here

T2M2, 8DR, 6A, FUSE, LQ2

Item#:
T2MK3F8Q2
You must be logged in to order this item. Log in here

D Cell Lithium - Control Panel Battery

Item#:
500205/LSH20
You must be logged in to order this item. Log in here

Rectifier with 6 Leads - 3 Am p

Item#:
10R3-6
You must be logged in to order this item. Log in here
|◀ ◀ 565 - 576 of 747 ▶ ▶|
View:
(Denotes required field.)