S2K Commerce - Products Dropdown
S2K Commerce - Shopping Cart
S2K Commerce - Order Entry
- LTE and IP connection tested every day
- Three selectable reporting paths: LTE cellular only, IP only, or IP Primary with LTE cellular backup
- Requires no change to the existing FACP configuration
- Connects directly to the primary and secondary telephone ports of a DACT
- Plan choices range from 5 minute, 60 minute, 6 hour, and 24 hour supervision intervals
- Operates over the following communication protocols: LTE, HSPA+(4G) HSPA (3G)
- Works over any type of customer provided Ethernet 10/100 based network connection
- (LAN or WAN), DSL model or cable modem
- Data transmits over standard contact ID protocol but is secured with the industry's advanced encryption standard (AES 256 bit)
- Supports both dynamic (DHCP) or public and private Static IP addressing
- Reliable connection: IP and cellular connection tested every day
- Built-in, stand alone Power Supply module. On board charging circuit design accommodates battery back-up. Includes primary power and battery supervision
- Diagnostic LEDs indicate signal strength and status
- QOS: Quality of Service diagnostics via AlarmNet conveys vital communicator information including signal strength, message path used, and when the message was received
- 7720P Hand-held programmer for easy setupChoice of LTE provider services
- Combination FACP / Commercial Fire Cellular Communicator.
Supports 8 conventional zones, expandable to 32 through analog addressable, wireless and conventional fire devices.
2 programmable NAC circuits, 2A each @ 24V.
Fire annunciator on door, support for up to 6 additional remote annunciators.
No programming required, pre-programmed with sprinkler supervisory / basic fire program. Advanced programming Over The Air
using NAPCO QuickLoader.
System is completely prewired and assembled, just mount on wall,
connect AC, ground, initiating and indicating devices and it is ready to go.
Lowest Equipment Cost Available for Any Full-Featured Cell Reporting Fire Alarm Solution
Saves Both Installation Time & Money
PRODUCT FEATURES
- Powers directly from a 12 or 24VDC alarm panel — no electrician needed for an outlet. Or, for AC, use included plug-in adapter.
- Operates on LTE-M networks, for 5G longevity, lower power consumption, and better in-building penetration.
- Interfaces with fire panels using a single DACT connection for universal compatibility.
- American made and backed by award-winning, US-based tech support.
- Dial capture allows for easy plug-and-play
- Compliant with 2019 and earlier editions of NFPA 72
- Meets UL 864 requirements for sole, primary or backup path communications
- 5-minute or 60-minute supervision
- Dual communication paths - If the Internet connection is interrupted or the LAN goes down, always-on 5G cellular will immediately step in.
- Powers directly from the fire panel’s 12V/24V auxiliary power supply or via plug-in transformer (included).
- Uses LTE-M bands for 4G and 5G network compatibility, better building penetration, and longest product life.
- Interfaces with panel over a single DACT connection for universal compatibility (use TG-PEM accessory when panel has no DACT).
- Telguard communicators are compatible with more alarm formats than any other brand. The signal will reliably get to the central station.
Features
- Dual communication paths - If the Internet connection is interrupted or the LAN goes down, always-on 5G cellular will immediately step in.
- Powers directly from the fire panel’s 12V/24V auxiliary power supply or via plug-in transformer (included).
- Uses LTE-M bands for 4G and 5G network compatibility, better building penetration, and longest product life.
- Interfaces with panel over a single DACT connection for universal compatibility (use TG-PEM accessory when panel has no DACT).
- Telguard communicators are compatible with more alarm formats than any other brand. The signal will reliably get to the central station.