|◀ 13 - 24 of 210 ▶|
View:

  • Z-Wave Plus Certified with the ZW500 chipset
  • The perfect solution for home office, storage room, or interior garage door where the security of a deadbolt is not required.
  • Works with Amazon Alexa via Samsung SmartThings and/or Wink
Item#:
99120-038
You must be logged in to order this item. Log in here

Features

  • 700-series Z-Wave Plus support – Longer range wireless capability
  • Humidity sensing and control
  • SmartStart Support
  • S2 authentication security
  • Can be powered by an HVAC system’s 24VAC “C” wire
Item#:
2GIG-STZ-1
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
The M1XSLZW is a specialized Elk-M1 serial expander for connecting an M1 Control to Z-Wave enabled devices through a Leviton VRC0P+3 Z-Wave Serial Interface. Z-Wave is a wireless, low power, "mesh" network technology widely used for automating devices such as: Lights, Thermostats, Electronic Locks, etc. Z-Wave empowers devices to be remotely controlled from across the room or across the world with benefits such as energy savings, convenience, and comfort.
The VRC0P+3 is known as a Z-Wave Secondary Controller. It must be included as a permanent member of the Z-Wave network as its job is to maintain contact with all Z-Wave devices. It communicates via RS232 to the M1XSLZW which translates the protocol into the M1 control. This allows commands to be sent and received on the Z-Wave network.
  • Activity/Status LED (Orange)
  • Auto-Reset Hardware Watchdog Circuit
  • Addressable (1-7) TYPE 5 Databus ID
  • Connection to VRC0P+3: DB9M 9 Pin Port
  • Connection to M1: Elevator Screw Terminals (4)
  • Operating Voltage: 12 Volts D.C.
  • Current Draw: 31mA
  • Housing: 4.25" x 6.375" x 2.125"
  • Circuit Board: 2.25" x 3.95"
Item#:
M1XSLZW
You must be logged in to order this item. Log in here
Use the Corner Kit to angle the Ring Video Doorbell towards a walkway, to improve motion detection and a better view of visitors.
  • Comes with 3 stackable wedges
  • Adjust viewing angle from 15°, 30° and 45°
  • Paintable to match home
Item#:
RVD2 CORNER KIT
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
Item#:
AYRDDDV8032619
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
|◀ 13 - 24 of 210 ▶|
View:
(Denotes required field.)