Home  >  Access Control  >  Controls/Panels  > Access and Power Integration - (4) Door, PTC Outputs Kit includes: Trove1

Access and Power Integration - (4) Door, PTC Outputs Kit includes: Trove1 enclosure with TM1 Altronix/Mercury backplane

Item #:T1MK1F4SD 
You must be logged in to order this item.
Log in here
Trove Mercury kit
Altronix T1MK1F4SD Trove Mercury kit is pre-assembled and consists of Trove1M1 enclosure/ backplane with factory installed Altronix power supply/charger and sub-assemblies. This kit also accommodates various combinations of Mercury boards for up to four (4) doors in a single enclosure. Trove simplifies board layout and wire management, reduces installation time and labor costs.
Power Supply (eFlow4NB):
Input
  • Voltage: 120VAC, 60Hz.
  • Fusing: 5A / 250V.
Output
  • Voltage: 24VDC.
  • Current: 4A continuous.
  • Other: Overvoltage protection. Filtered and regulated.
Battery Backup
  • Capacity: 7AH / 12VDC (Up to 2 within enclosure). 40 AH / 65 AH (requires separate enclosure).
  • Type: Sealed lead acid or gel type.
  • Fuse: Rating 10A/32V.
  • Failover: Upon AC loss, instantaneous.
Supervision
  • AC Failure: Form “C” contacts.
  • Battery: Form “C” contacts.
  • Low DC Power Shutdown: Shuts down DC output terminals if battery voltage drops below 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
Indicators LED
  • Input: 120VAC is present.
  • DC Output: Powered.
  • Battery: Discharged or not connected.
Voltage Regulator (VR6):
Input
  • Voltage: 24VDC from eFlow4NB.
Output
  • Voltage: 12VDC.
  • Current: 6A continuous.
  • Other: Surge suppression.
Indicators (LED)
  • Input: 24VDC is present.
  • Output: Powered.
Access Power Controller (ACM4CB):
Input
  • Voltage: 24VDC from eFlow4NB.
  • Fusing: 10A / 250V.
Output
  • Voltage: 24VDC.
  • Four (4) independently controlled 2.5A outputs:
  • a) Four (4) Fail-Safe and/or Fail-Secure power outputs.
  • b) Any combination of the above.
  • Four (4) auxiliary power outputs (unswitched).
Outputs Ratings
  • PTCs: 2.5A.
Indicators (LED)
  • Red LEDs: Outputs are triggered (relays energized).
  • Green LED: FACP disconnect is triggered.
Dual Input Power Distribution Module (PDS8CB):
Input
  • Voltage: 12VDC from VR6 and 24VDC from eFlow4NB.
  • Main Fuse Rating: 10A.
Output
  • Voltage: 12VDC and/or 24VDC.
  • Any of the eight (8) power outputs are selectable to follow power Input 1 or Input 2.
  • Individual outputs may be set to OFF position for servicing.
Outputs Ratings
  • PTCs: 2A.
Indicators (LED)
  • DC Output: Eight (8) individual output LEDs.

Access Control Controls/Panels

Brand
Altronix
Trove Mercury kit
Access and Power Integration - (4) Door, PTC Outputs Kit includes: Trove1 enclosure with TM1 Altronix/Mercury backplane
Quantity:
(Denotes required field.)