Increases the total EC-50/100 Power output to 100W

The ECC-50/100 and ECC-50/100E are multipurpose emergency voice evacuation panels that may be used for fire applications, mass notification applications or both. These state-of the-art Primary Operator Consoles (POCs) are capable of producing either 50 or 100 watts of audio power that can be distributed to up to eight speaker circuits (i.e., zones).

Features

• UL Listed to UL2572 Communication (Control Units Mass Notification Systems).
• Modular design for maximum system flexibility and easy expansion.
• 50 watts of 25 V audio power (expandable to 100 watts) RMS.
• Optional amplifier can be configured as a backup in the event the primary amplifier fails. Amplifiers are independently powered to eliminate system interruption during a short circuit condition
• Eight Command Input Circuits to activate messages 1 to 8:
• Seamless integration and control when connected to select Fire-Lite panels through the ANN/ACS (EIA-485) communication bus.
• Speaker circuits are expandable by up to 8 outputs (With an optional circuit expander module).
• Removable terminal blocks for ease of servicing and module replacement.
• 2 amp Notification Appliance Circuit (NAC) output, sync generator, or follower for System Sensor, Wheelock or Gentex protocols:
• Integral supervised microphone.
• 520HZ square wave tones can be uploaded to ECC-50/100 to meet NFPA Low Frequency requirements

Supervises up to 5 remote microphones

• Each unit includes four onboard fully supervised audio circuits which are expandable to eight circuits when an ECC-CE4 module is added
• Any combination of up to eight ECC-50DAs or ECC-125DAs per system for a total of 1100 watts of audio power and 24 speaker circuit outputs.
• Supports both Class A (Style Z) and Class B (Style Y) wiring.
• Easy setup and configuration by using a simple, built-in web based programming utility on the ECC-50/100
• UL2572 (Communication and Control Units Mass Notification Systems).
• Built-in power supply and battery charger that supports up to 35AH. (For batteries larger than 18 AH, use the BB-26 or BB-55F Battery Box.)
• ECC-50DA is field selectable for 25 volts or 70.7 volts of operation.
• Sturdy, scratch resistant cabinet.

Features

• Clean Dead-front Construction
• 8 Megabyte MP3 driver
• 25 or 70 VRMS Field Selectable Class A / B Speaker Circuit
• 120 VAC Power Supply and Battery Charger
• Live Microphone Override of Message and Tone
• Analog Addressable Compatible
• High Reliability, No Maintenance, Fully Supervised
• Easy Installation and Operation
• Studio Quality Voice Recordings Built in Alarm and Alert Signals
• Works with 12 or 24VDC Fire Alarm Panels Works with Microprocessor based and Networked Fire Alarm Systems
• 3 Minute Message Restart on Microphone Key
• 24 Hour Backup with two 12V 7AHr Batteries

Provides Connections for up to Six Style Z (Class A) or Style Y

Increases the total EC-50/100 Power output to 100W

The EVX-RM is a supervised remote microphone for use with the EVAX 25(50) voice evacuation system. The microphone provides crystal-clear live voice messages over the system speakers. Ideal for use when the fire alarm panels are in an electrical room, and the annunciator and microphone are in the lobby.

Features

• All-Call Remote Microphone
• Overrides alarm tone and automatic message
• Dead Front Cover Construction
• Paging microphone with Press To Talk Button
• In-Use and Fault LEDs
• Supervised Wiring
• May be located up to 5000 feet away from Voice Evac Panel