The Pace1PTM is a long range Ethernet transceiver designed for use with Pace1PRM, Pace4PRM, Pace8PRM and Pace16PRM receivers. They transmit data at 100mbps full duplex and power via a single twisted pair (UTP) (when paired with Pace1PRM) or Cat5e or higher cable in a PoE(+) compliant format. The Pace1PTM will not deliver power to non compliant devices, thus avoiding damage to improperly connected non-PoE cameras/devices. The receiver passes the PoE(+) compliant power over the cable to the Pace1PTM transceiver which in turn passes this power to an enabled IP camera/device. These plug and play units facilitate cost effective solutions for IP devices that need to be installed at distances greater than 100m. They also provide a simple way to replace legacy analog products with new IP devices over single twisted pair (UTP) (when paired with Pace1PRM) or structured cable.

Altronix T2KK3F8DQ is pre-assembled and consists of Trove2 enclosure with factory installed Altronix power supply/chargers, transformer, and sub-assemblies. These kits also accommodates various combinations of Keyscan boards for up to eight (8) doors in a single enclosure.

• Input: 120VAC 60Hz/3.5A.
• Output:
  • 24VDC up to 5.8A max current.
  • Eight (8) Fail-Safe/Fail-Secure Outputs (auto-resettable).
• Fully assembled kit includes:
  • Trove2 enclosure with TKA2 backplane
  • One (1) eFlow6NB - Power Supply/Charger
  • One (1) LINQ2 - Network Communications Module
  • One (1) ACM8CB - PTC Access Power Controller
  • One (1) T16100 Transformer
• Back-up Battery (not included):
  • Capacity: 12AH / 12VDC (Up to 4 within enclosure); 40 AH / 65 AH (requires separate enclosure).
  • Type - Sealed lead acid or gel type.
  • Fuse Rating: 10A/32V.
  • Failover - Upon AC loss, instantaneous.
• Supervision:
  • AC Failure - Form "C" contacts.
  • Battery - Form "C" contacts.
  • Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
• LED Indicators:
  • Input - 120VAC is present.
  • DC Output - Powered.
  • Battery - Discharged or not connected.