|◀ 133 - 144 of 454 ▶|
View:
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here

Features:

  • New super compact design, 2.5 x 1 x 0.4 (HxWxD inches)
  • Tamper supervised
  • Replaceable lithium PL2032 coin cell battery (supplied)
  • 5-year battery life, typical
  • Magnet and Internal reed switch
  • External lead (24 in. mini connector pigtail) for wiring external devices (jumper-selectable)
  • Magnet mounts with either supplied double-face tape or screws (screwtabs snap off mounting plate)

Item#:
GEM-TRANSLP-BRN
You must be logged in to order this item. Log in here

The M1XRFTWM two-way wireless transceivers allow an ELK-M1 or ELK-M1EZ8 control to accept Elk's complete line of two-way wireless sensors. The ELK-M1XRFTWM has been optimized to provide superior signal reception and reliability in multi-transceiver applications.
The ELK-M1XRFTW has been replaced by the ELK-M1XRFTWM. The ELK-M1XRFTWM performs all the functions of the ELK-M1XRFTW and is suitable for single or multiple transceiver installations.
DO NOT mix ELK-M1XRFTW and ELK-M1XRFTWM transceivers in a single M1 installation.
Includes:

  • Two Way Wireless Transceiver
  • Plastic Housing
  • (4) #6 Plastic Anchors
  • (4) # 6 Pan Head Sheet Metal Screws
  • Instructions
Features:
  • Allows up to 144 individual wireless zones (sensors/points)
  • Operates from the 4 wire RS-485 Data Bus
  • Up to 4 M1XRFTWM transceivers may be connected to a single M1 or M1EZ8 control for redundancy and greater coverage
  • Flash memory for firmware updates
Specifications:
  • Operating Frequency: 902 Mhz to 928 Mhz
  • Sensitivity: >105 dbm
  • Operating Temperature: 0 to +120 degrees F
  • Operating Voltage: 12 Volts D.C.
  • Current Draw: 25mA receiving, 85mA transmitting
  • Housing Dimensions: 6.75 in. x 4.69 in. x 1.13 in.

Item#:
M1XRFTWM
You must be logged in to order this item. Log in here
Item#:
GEM-KEYF-LR
You must be logged in to order this item. Log in here
  • Uses LTE cellular network for high-speed, reliable and low-cost communications to an IP receiver Automatically switches to 3G (HSPA/ HSPA+) if LTE service is not available
  • Compatible with control panels that communicate using the Contact ID and SIA (300 baud) formats
  • Full event reporting
  • 2 on-board inputs
  • 2 on-board outputs (open collector)
  • Activation and initialization via website or mobile interface provided by C24 Communications
  • View communicator status directly from your mobile phone to support on-site or remote troubleshooting
  • PTM (Panel Transmission Monitor) switches from PSTN to cellular on unsuccessful communication attempts
  • SMS command & control for panel arm/disarm
  • PTM call routing to direct cellular signals to multiple receivers based on dialed number
  • Advanced carrier selection to secure a suitable cellular connection
  • Two unique trouble display models
  • Compatible with Sur-Gard System I-IP/II/III/IV/5 monitoring station receivers
  • Mobile Site for Easy Installation and Comprehensive Maintenance
  • Advanced Panel Transmission Monitoring
  • SMS Command & Control
  • Input Voltage 13.8 Vdc
  • Current Draw (without battery) 40 mA (standby) 180 mA (transmitting)
  • The LE4000 has been listed by UL/ULC for Residential Fire and Burglary and UL/ULC Commercial Burglary installations.
  • Dimensions 8.5" H x 4.9" W x 1.3" D (216mm x 124mm x 33mm)
Item#:
LE4000RF-ADTAT
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
|◀ 133 - 144 of 454 ▶|
View:
(Denotes required field.)