• Price competitive with all other card technologies.
• Offers universal compatibility with all HID proximity card readers.
• Provides durable packaging and consistent read range.
• Provides an external number for easy identification and access control.
• Supports formats up to 85 bits, with over 137 billion codes.
• Custom pre-printed artwork available.
• A PVC overlay allows for on-site photo ID using most direct image printers.
• Thin enough to carry in a wallet or purse.
• Create Photo ID card with model 1324 Printable Adhesive Label

Features

• Advanced soft touch piezoelectric switch
• New weatherproof design  water and dust proof, grease, oil and other chemical solvent repellent
• Circuit assembly encapsulation
• Vandal resistant
• Stainless steel mounting plate and tactile button with no moving parts
• Mounting Method Single Gang: Mounts directly to a US gang switchbox

• High visibility 2" square button
• Single gang stainless steel faceplate
• 'C' and 'U' models offer the largest selection of insert labels (see info below for labels included)
• 'E' model offers economical single label 'Push to Exit' version
• LED bulb provides super-bright operation and longevity (10 yr estimate)
• 3yr. 'Camden Tough' warranty with '2 for 1' replacement

Altronix ACM4 converts one (1) 12 to 24 VAC or VDC input into four (4) independently controlled fuse protected outputs. These power outputs can be converted to dry form C contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. ACM4 will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. Units are designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the four (4) outputs.

Features

• Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the four (4) outputs.
  Fire Alarm disconnect input options:
  • a) Normally open (NO) or normally closed (NC) dry contact input.
  • b) Polarity reversal input from FACP signaling circuit.
• FACP output relay (form "C" contact rated @ 1A 28VDC not evaluated by UL).
• Removable terminal blocks facilitate ease of installation.